Filesystem loader has serial debugging enabled. GVP 2040 original ROM image added (No 68060 support). Debugger wf didn't fill in binary mode. Debugger breakpoints are now also reported when single stepping (f and fo etc), previously trace override other breakpoint detection.
Filter mode "default" now always scales if programmed chipset display mode. Bitmap block used original DD block location but was allocated after HD root block. Mounting exe as HD floppy image created broken disk structure if file was larger than 1329664 bytes. When disk image is ejected using GUI, close image file handle immediately (previously it was closed after returning back to emulation) Disk image was accidentally opened twice, preventing disk image deletion/editing without closing WinUAE (b1) HAM5/HAM7 was incorrectly allowed in AGA mode (broken probably in 4.9?). This was done before logic analyzer checks and was forgotten.
This is same address OR behavior as any other DMA pointer if more than one gets activated in same cycle (for example refresh + bitplane conflict).
This usually indirectly stops the copper because it will sooner or later does MOVE to "dangerous" register. COPJMP1+COPJMP2 strobe when Copper DMA is off stops the copper: this was not correct, if both strobes are generated, Copper instruction pointer is loaded with COP1PT OR'd with COP2PT. LOL (NTSC long line) was toggled 1 cycle too early. (Toggled 3 cycles too early, correct position is cycle 1 of line 0) Interlace automatic LOF toggle cycle was still using pre-4.9 horizontal position origin. Programmed mode "do not include hidden lines" (b1) removed one too many line, breaking some programmed modes interlace field order. Both keyboard reset modes now work identically. Keeping reset keys pressed more than 5 seconds force hard reset like non-reset warning config already did. Changed keyboard reset warning again: when reset keys are pressed, reset warning starts, when reset warning ends, system is reset but reset is kept active until at least one key is released.